jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 51 (kliknij aby zobaczyć)
11
11 Insert a flatblade screwdriver into the slot under the separation pad. Pry the pad up from the spring-loaded base by twisting the screwdriver until the tabs are separated from the printer. 12 Use one hand to push the spring-loaded base down and then use the other hand to pull the separation pad up and out of the printer. Note If you feel resistance when you try to remove the pad, make sure that the tabs are completely separated from the printer.
12
13 Push the spring-loaded base down and position the new separation pad in the empty slot. Note Make sure that the two tabs on the edge of the pad are toward the front of the printer.
13
14 Snap both sides of the separation pad firmly into place until they click. CAUTION If the pad is not straight, or if space exists between the pad and the base, make sure that the tabs on the pad are toward the front of the printer.
14
15 Hold down the new separation pad. Position the new pickup roller so that the button is on the right side, and the open side of the roller faces down. Make sure that the small ridge on the open side of the roller aligns with the groove in the shaft.
